The differential air pressure sensor transmitter is developed on the basis of industrial class advanced ICs technology.It can be used for the measurement for air pressure and air differential pressure . It can be used for air and other dry nonflammable gas without corrosive. By the built-in electronic wiring, the physical value can be transmitted to analog voltage and current output or digital serial port output with Modbus protocol. The differential pressure sensor is not used for pressure measurement of liquids.
The air differential pressure transmitter can provide high accuracy with low price. It is our standard type pressure transmitter.With metal enclosure and advanced air differential pressure sensor, the air differential pressure transducer can ensure high performance with good cost-effective solution. The differential pressure transmitters have been widely used for HVAC,building automation,electric power, environmental protection, dust removal,light spinning, leak detection, etc.
Explosion-Proof Air Differential Pressure Transmitter
- Electronic pressure measurement without moving parts
- Good accuracy with cost-effective solution
- Analog outputs: 4-20mA default
- 0-10VDC or 0-5VDC outputs optional
- Temperature compensation technology
- Compact design with solid structure
- Small size body and light weight
- Convenient to use and easy to install
- Zero point and measuring scope can be adjusted from outer
- Measuring Scope:0-100Pa to 100Kpa(Please specify while order)
- Measuring Way: Pressure,Differential pressure,Suitable for negative pressure of furnace hall pipe
- Power Supply: 24Vdc(default)
- Signal Output: (2-wire)4-20mA(default);0-5Vdc,0-10Vdc(3-wire) optional
- Compensation Temperature: -10-+70 ℃
- Working Temperature: -20-+85 ℃
- Comprehensive Accuracy: 0.5%
- Enclosure Material: Metal
Differential Pressure Air Sensor Transmitter
(Traditional Plastic Enclosure)
The air differential pressure transmitter has traditional plastic enclosure which is different from the metal enclosures above. The air pressure transmitter developed on the first class ICs with features of high sensitivity, high accuracy and strong over-loading. It has a high integration of sensor and amplifier wiring circuit. There is no need to adjust zero point of circuit. It has strong anti-interference and long-term stability.
- Good stability,full scale,zero position can reach 1%FS/year. With temperature compensation range of 0-70℃, its temperature shift is below 1%FS. In the whole allowing temperature range, the shift value is smaller than 0.5%FS.
- Wiring circuit has feature of reverse protection and current limiting protection
- Solid state design,no moving parts, high reliability and long life
- Accurate measurement from wind pressure to steam,not influenced by mass size of tested fluid
- Simple structure,simple to install and economic to use
- Pressure range:0-100Pa to 0-10000KPa
- Max over-load: 3 times over standard measuring range(usually refer to max pressure of one end)
- Pressure value:manometer pressure and micro differential pressure, negative pressure optional.
- Accuracy class: ±1%F.S. ±0.5%F.S. and ±0.2%F.S. optional
- Power supply: 24VDC (default)
- Measured fluid:Dry Air or Gas compatible
- Over-load resistor:<=500 ohm
- Analog output: 3-wire 4-20mA, 0-5V/0-10V. Default is 4-20mA
- RS485 Modbus and Relay switch function optional
- Temperature compensation range:0-70℃
- Display or not display optional
- Enclosure: ABS o